Products
Mu-Tron III Power Supply Remake
Clear Blue Mu-Tron III Power Supply Remake
Charge Pump Mu-Tron III Power Supply
Mu-Tron III Cable For Voodoo Labs
Mu-Tron III Bi-Phase Dual Foot Switch Remake
Set Of 4 Rubber Feet
6AL5 Distortion Pedal
All Tube 6AL5 Distortion Pedal
6AL5 Distortion Pedal $295 ( built to order ):
This pedal uses a 6AL5 twin diode vacuum tube to deliver a stunningly good organic tube distortion. It also has a special high voltage driver feeding into the 6AL5’s twin diodes. Like many distortion pedals it uses diodes to generate the distortion. The main difference with this one is that it uses high voltage driving tube diodes instead of semiconductor diodes.
Controls:
The Squash control ( S ) sets the level where the 6AL5’s twin diodes begin to distort. This control can be adjusted for cleanest at 0% to over-squash at 100% with the most distorted being about 65%. There are also two trimmers inside to adjust for the differences in the 6AL5’s used.
The Drive ( D ) control sets the gain of the signal going to the 6AL5’s twin diodes.
The Level ( L ) control sets the pedal output level.
For now these will be sold on a built to order basis. Price: $295 plus $15 Shipping/ Handling.
Top of page
All Tube 6AL5 Distortion Pedal $395 ( built to order ) :
Also available for order is the all tube version in a larger case. This version has a Bright switch and a Fat switch using three position toggle switches for two settings each with center being off. Comes included with a reissue Tung-Sol 12AX7 and a 6AL5 twin diode tube that may be of any manufacturer.
For now these will be sold on a built to order basis. Price: $395 plus $15 Shipping/ Handling.
USA orders only. Will ship only within the United States.
Top of page
Mu-Tron III Power Supply Remake $49 :
This is a remake of the PS-1 power supply for the
Mu-Tron III. This power supply uses the same tried and tested
circuitry of the original, with the exception of a wall type
transformer and the rectifier configuration. It has improved power filtering and a red dot type LED power indicator. The above picture is the complete power supply setup with wall transformer. It has the same 3 pin plug the original
PS-1 has and it plugs into the 3 pin jack in the middle on the back of
the Mu-tron III. The wall transformer's 2.1mm plug connects
to a jack on the power supply box. Some of the very early Mu-tron III's
do not have the 3 pin jack.
Note: This power supply is not for "Haz Labs" products.
The power supply sells for $49 + $10 shipping/ handling + sales tax if you live in California. If not using PayPal please send a check or money order for $59 or $63.29 if in California. I can accept check, money order or PayPal.
Quantities are limited. USA orders only. Will ship only within the United States.
Top of page
Clear Blue Mu-Tron III Power Supply Remake $49 :
This is a remake of the PS-1 power supply for the
Mu-Tron III with a clear blue case. This power supply uses the same tried and tested
circuitry of the original, with the exception of a wall type
transformer and the rectifier configuration. It has improved power filtering and a blue LED power indicator. The above picture is the complete power supply setup with wall transformer. It has the same 3 pin plug the original
PS-1 has and it plugs into the 3 pin jack in the middle on the back of
the Mu-tron III. The wall transformer's 2.1mm plug connects
to a jack on the power supply box. Some of the very early Mu-tron III's
do not have the 3 pin jack.
Note: This power supply is not for "Haz Labs" products.
The power supply sells for $49 + $10 shipping/ handling + sales tax if you live in California. If not using PayPal please send a check or money order for $59 or $63.29 if in California. I can accept check, money order or PayPal.
Quantities are limited. USA orders only. Will ship only within the United States.
Top of page
Charge Pump Power Supply For The Mu-Tron III $59 :
This version of the power supply is for use with standard 9 or 9.6 volt DC pedal board power ( 2.1mm negative center connector ).
It uses a charge pump chip to get the needed negative 9 volts DC.
It is in a clear blue case, has power filtering and a blue LED power indicator. It has the same 3 pin plug the original
PS-1 has and it plugs into the 3 pin jack in the middle on the back of
the Mu-tron III. The 2.1mm cable included connects from your pedal board power
to a jack on the power supply box. Some of the very early Mu-tron III's
do not have the 3 pin jack. Wall transformer not included.
Note: This power supply is not for "Haz Labs" products.
The power supply sells for $59 + $10 shipping/ handling + sales tax if you live in California.
Quantities are limited. USA orders only. Will ship only within the United States.
Top of page
Mu-Tron III Power Cable For Voodoo Labs $29 :
This is a power cable for the Mu-Tron III for use with Voodoo Labs Power Supplies. Just use two of the 9 volt DC negative center jacks on the Voodoo Labs Pedal Power Supply. The Cable sells for $29 + $10 Shipping/Handling + sales tax if in California. I can accept check, money order or Pay Pal.
Note: This power cable is not for "Haz Labs" products.
Note: This power cable relies on the isolated output feature of the Voodoo Labs Pedal Power and you will need this unit or an other power supply with completely isolated 9 volt DC negative center outputs to use this cable.
Quantities are limited. USA orders only. Will ship only within the United States
Top of page
Mu-Tron Bi-Phase Foot Controller Remake *SOLD OUT* :
This control pedal is made from a wah pedal. It connects to the five pin jack on the Bi-Phase. It is sold complete with a dual foot switch that plugs into the side of the control pedal. The foot switch built into the control pedal is used to bypass both phasor banks and overrides the dual foot switch. The Bi-Phase Foot Controller sells for $175 + $15 Shipping/Handling + sales tax if in California. I can accept check, money order or PayPal.
Quantities are limited. USA orders only. Will ship only within the United States
Top of page
Mu-Tron Bi-Phase Dual Foot Switch Remake $49 :
This dual foot switch connects directly to the five pin jack on the Bi-Phase. It is used to turn on and off the two phasor banks. The Bi-Phase Dual Foot Switch sells for $49 + $10 Shipping/Handling + sales tax if in California. I can accept check, money order or PayPal.
Quantities are limited. USA orders only. Will ship only within the United States
Top of page
Set of 4 Rubber Feet with Stainless Steel Screws for Wah Pedals or other Effects $3.50 :
$3.50 + $7 Shipping/Handling + sales tax if in California. USA orders only. Will ship only within the United States.
Top of page